MOTORCYCLE / AUTO

   HOME   l   ROTAX   l   AUTO   l   4 CHANNEL ADAPTER KIT   l   4 WHERE TO BUY   l   CONTACT US
 

4-channel adaptor kit  TS-220

Converts CarbMate or SynchroMate into a 4 carb/throttle valve synchroniser

This easy-to-mount & easy-to-use kit allows connection of CarbMate's 2 channels (tubes) to 4 carbs / throttle valves at once.

To fit: remove the CarbMate from it's rubber protective holder, pass the tongue of the adapter through the end hole in the rubber holder so that the fold in the adapter plate rests on the lower edge of the hole in the holder. Then replace the CarbMate in the holder so that the tongue of the adapter is gripped between the housing of the SynchroMate & the bottom of the holder. The adapter can be left permanently mounted like this if preferred, or easily & quickly removed & subsequently remounted.

The rubber tubes exiting the SynchroMate can be left at original length or cut down to suit if the 4-channel kit is to be permanently mounted.
 

How to use the 4 channel adapter kit
on 4 carburettors / throttle valves

Preparation:

There are normally three adjustable links between 4 carburettors.
For synchronising purposes the carbs are split into two pairs.
Attach tube 1 to the leading or reference carburettor (the accelerator cable is attached to this carburettor).
Attach tube 2 to the other in the pair containing the leading carburettor.
Attach tube 3 to the first carb in the second pair.
Attach tube 4 to the remaining carb.
Synchronise in 3 easy steps:
Select tubes 1 and 2 to synchronise the first pair of carburettors.
Select tubes 3 & 4 to synchronise the second pair of carburettors.
Finally, select tubes 1 and 3 to synchronise the two pairs of carburettors.
HOME   l   ROTAX   l   AUTO   l   4 CHANNEL ADAPTER KIT   l   4 WHERE TO BUY   l   CONTACT US
Copyright © 2012. TecMate. All Rights Reserved.
domain registration and web hosting by uniwebserve south africa